PDA

View Full Version : Example code



azmax100
07-16-2009, 04:20 PM
I need to send serial protocol to a serial servo. As serout command in BS2.

Can somebody show me an example code.

Thanks.

Mike Green
07-16-2009, 08:42 PM
This is the Propeller forum. You're asking for information about a Basic Stamp and the question should be posted in the Stamp forum.

You need to supply more information. There are several different servos on the market that use a serial protocol. You would need to post a datasheet / manual or at least a link to a datasheet / manual that describes the protocol.

Joms
07-21-2009, 08:08 AM
If you are trying to send serial data out of a prop you will need to use a serial object. The most common one is Full Duplex Serial but there are many versions of it that are available in the Object Exchange. obex.parallax.com

Look at the documentation of each object and that should get you on a big start...