PDA

View Full Version : Status register SPI mode of Vinculum ( VDIP1 )



Minos
07-02-2009, 02:57 PM
HI

I use the Vinculum of FTDI in SPI mode

Have you a documentation of status register

also· bit· RXF#· ( bit0)
··········· TXE#· (bit1)
··········· RXF IRQEn· (bit4)
··········· TXE IRQEn·· (bit5)

So when I want read the status register
and when there aren't caractere in buffer RX what is the value
of RXF#

is 0 or 1 ?

And when I receive a caractere ( buffer full )

Thank you
··········

DogP
07-02-2009, 03:42 PM
Dude... seriously... you can reply to your own posts rather than starting new ones asking the same thing. And this is definitely the wrong forum to ask about using a VNC1L board with an AVR microcontroller. Vinculum's documentation is pretty bad, but they've been pretty quick with replies every time I've emailed them... I'd suggest you try emailing their support ( www.vinculum.com/contact.html (http://www.vinculum.com/contact.html) ) since you haven't gotten the answer you're looking for in your 4 posts about this.

DogP