PDA

View Full Version : Quick questions about Hydra-Net port..



RobotWorkshop
04-21-2008, 06:19 AM
I've got everything wired up and working perfect on my Hydra clone with the exception of one last thing. The TX and the RX lines to the RJ-11 jack. Since I don't have access to a real Hydra board I just want to confirm those connections. If I look at the end of the jack where the cable plugs in with the wires at the top and the catch on the bottom what is the orientation of the RX and TX? Would the TX be on the right or left (of the center two pins)? Once I confirm that I can wire them up.

Robert

kuroneko
04-21-2008, 07:04 AM
RobotWorkshop said...
If I look at the end of the jack where the cable plugs in with the wires at the top and the catch on the bottom what is the orientation of the RX and TX? Would the TX be on the right or left (of the center two pins)?


Looking into the socket it is GND - RX - TX - GND (TX -> R43, RX -> R23).